Supplied accessories
Make sure the following accessories are provided with the product.
Remote control unit | “AAA” size battery | AC cord | Cable clamp (g2) | Stand unit | Operation manual |
(g1) | (g2) | (g1) | Cable tie (g1) | (g1) | (g1) |
Page 8 | Page 8 | Page 7 | Page 7 | Page 6 |
|
NOTE
•Always use the AC cord supplied with the TV.
•AC cord enclosed in this product is for
SHARP ELECTRONICS CORPORATION
6100 Blue Lagoon Drive, Suite 230, Miami, Florida 33126, U.S.A.
QUICK REFERENCE
Attaching the stand
•Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
•Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
•Attach the stand in the correct direction.
•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1Confi rm that there are 10 screws (6 short screws and 4 long screws) supplied with the TV.
2Attach the two supporting posts for the stand unit onto the base using the box for the stand unit as shown below.
31 Insert the stand into the openings on the bottom of the TV.
2 Insert and tighten the 4 long screws into the 4 holes on the rear of the TV.
Hex key 
2 | Long | 2 |
screw
Soft cushion
3
2 | 3 |
| Hex key |
1
2
1
Short screw 
1Insert each of the protrusions on the two supporting posts into the openings on the upper side of the base.
2Insert and tighten the 6 short screws with
the hex key (supplied with the product) in the order of 1, 2 and 3.
1
NOTE
• To detach the stand, perform the steps in reverse order.
6