![](/images/backgrounds/175972/bgb.png)
9
QUICK REFERENCEAttaching the Stand
• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
•After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.
•Do not remove the stand from the TV unless using a wall mount bracket to mount it.
5The case is equipped with push-in tabs to hold
the cushioning materials in place. Push in the
tabs (2 for each location) to secure the cushioning
materials in the case. Push-in tabs
6After you have built the work table, spread a
blanket or similar soft cloth over the table and then
lay the TV display down on the covered table.
• Do not use a small table for this.
■ Attaching the Stand to the TV
7Insert the stand into the openings on the bottom of
the TV.
• Make sure that the stand is fi rmly inserted into the TV.
Improper installation may result in tilting of the TV set.
8Insert and tighten the 4 screws into the 4 holes on
the rear of the TV.
Short
screws
• In the installation procedure, be careful not to catch your
fi ngers between the TV set and the fl oor.
Before attaching the stand to the TV, build a work
table on which to rest the TV.
• To build the table, use the cushioning materials used in the
packaging.
TOP-C
FRONT
TOP-L
TOP-R
• Of the cushioning materials used, TOP-C is also used
during stand unit assembly. Be sure to assemble the stand
unit before building the work table.
■ Stand Unit Assembly
1Confi rm that there are 12 screws (8 long screws
and 4 short screws) supplied with the stand unit.
21Set the post for the stand unit onto the TOP-C.
2Attach the base to the post.
3Insert and tighten the 8 screws into the 8 holes
on the bottom of the base.
•Hold the stand unit securely with one hand, and then
tighten the screws.
FRONT
1
1
2
3
Long
screws
■ Building the Work Table
3Attach the joints and close the case.
1Insert a joint into the hole on the side of the case.
2Pressing the tab, fi x the joint into place.
1
2
4Insert each of the cushioning materials in the
respective directions shown in the fi gure.
• Insert TOP-L and TOP-R into the left and right sides of
the case respectively.
• Insert TOP-C to fi t between the lines on the other side
of the case. TOP-L
TOP-R
JOINT
CASE
LINE
TOP-C