22
Watching TV
Changing channels - Analog-TV
You can change channels in several ways.
NOTE
• While watching a broad cast, press A-ANALOG-B to view
the image received from the other tuner.
Method 1
Using CHr/s on the remote control unit or on the
display.
Method 2
1. Press FLASHBACK to switch to the previously tuned
channel.
2. Press FLASHBACK again to switch back to the
currently tuned channel.
NOTE
•FLASHBACK will not work if no channel has been
changed after TV is turned on.

Method 3

Using remote control buttons (0-9 andENTER) to select

up to 125 channels for VHF/UHF/CATV.

To select a 1 or 2-digit channel number

(e. g., Channel 5):

Press 5s ENTER

NOTE
• When selecting a 1-digit channel number, it is not
necessary to press 0 before the number.
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
• • (DOT) can be used instead of ENTER.

To select a 3-digit channel number

(e. g., Channel 115):

Press 1s1s5

NOTE
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
• If you push “0” by itself, nothing will happen.
Changing channels - Digital-TV
You can change channels in several ways.
As well as the methods outlined below, you can also select
programs using the Channel List. (See page 85.)
NOTE
• While watching a broad cast, press DIGITAL.

Digital - Air/Cable

Method 1
When you press CHr/sor FLASHBACK, repeat the
same steps for Analog-TV.
Method 2
Using remote control buttons (0-9, •(DOT) and

ENTER) to select the channels including a decimal

point.

To select a 4-digit channel number

(e. g., Channel 22.1):

Press 2 s2s•(DOT) s1s ENTER

NOTE
• Complete the above steps within a few seconds.
• When you enter 0-9 and •(DOT), channel selection will
be made if there is no operation for a few seconds.
• When entering a 2-part channel number, pushing •(DOT)
after the second part of the number has the same function
as ENTER.

Digital - Cable (One-part Number)

Method 1
When you press CHr/sor FLASHBACK, repeat the
same steps for Analog-TV.
Method 2
Using remote control buttons (0-9 andENTER) to select

the channels including a decimal point.

To select a 3-digit channel number

(e. g., Channel 310):

Press 3s1s0sENTER

NOTE
• When you enter 0-9 only, channel selection will be made
if there is no operation for a few seconds.
• •(DOT) can be used instead of ENTER.
• Digital Cable Channels are shown by a number with a
maximum of 5 digits.
5
ANALOG-A Air
5
ANALOG-A Air
11
ANALOG-B Cable
1
ANALOG-B Cable
115
ANALOG-B Cable
22.
DIGITAL Air DIGITAL Air
22.122.1
DIGITAL Air
22
DIGITAL Air
2
DIGITAL Air
310
DIGITAL Cable
310
DIGITAL Cable
31
DIGITAL Cable
3
DIGITAL Cable