Supplied accessories
Confirm that the following accessories have been provided with the product. |
| |
□ Mounting bracket x 2 | □ Countersunk bolt (M10) x 2 | □ M16 plain washer x 4 |
□ M8 bolt x 4 | □ M8 spring washer x 4 | □ M10 (countersunk bolt) plain washer x 2 |
□ M10 bolt x 4 | □ M8 plain washer x 4 | □ Operation manual (this manual) |
□ M16 bolt x 8 | □ M16 spring washer x 4 |
|
Precautions on use
•The installation, removal, or transportation of the LCD Monitor must be performed by qualified service personnel. The LCD Monitor is large and heavy. Installation requires special knowledge and qualifications.
•Customers should not attempt to install, remove, or transport the LCD Monitor by themselves.
•SHARP shall have no liability for any accidents or damages caused by improper installation or mishandling.
•The installation requires two
Installation procedure
Caution
•The LCD Monitor is large and heavy. It must be moved with a hoisting device (chain block, etc.).
•Installation requires at least four people.
4 Attach the mounting brackets on the rear of the LCD Monitor.
1)Attach 4 supplied M16 bolts, 2 on the right and 2 on the left as shown below, and slightly tighten the bolts.
2)Attach the mounting brackets by inserting the bolts through the 2 holes in the center.
3)Secure the mounting brackets with 4 supplied M16 bolts inserted into the remaining 2 holes on each side.
M16 plain washer
M16 spring washer
6 Attach the LCD Monitor (mounting brackets) to the
1)Hook the bottoms of the mounting brackets to the bolts attached in step 5.
2)Confirm that the mounting brackets are securely hooked and then attach the 2 supplied countersunk bolts.
3)Tighten the countersunk bolts while gradually loosening the chains of the hoisting device.
Countersunk bolt
Countersunk bolt plain washer
1 Move the LCD Monitor in front of the
2 Insert the hooks of the hoisting device into the eye bolts of the LCD Monitor and slightly lift the monitor.
•Lift up the monitor so that the hoisting chains become taut.
3 Remove the stand mounting bolts on the rear and detach the LCD Monitor from the stand.
•Loosen the 8 bolts gradually and evenly.
If it is difficult to loosen the bolts, lift the monitor up slightly with the hoisting device to reduce the load on the bolts.
•Check the hoisting condition frequently to prevent the LCD Monitor from falling.
4)Fully tighten the bolts which were tightened halfway in step 1).
5 Attach the supplied M10 bolts to the
1)Attach the bolts onto the both sides of the right and left frames and ensure that all 4 of the bolts are aligned at the same height.
4)Insert the 4 supplied M8 bolts from the sides of the mounting brackets (2 for each) and secure them.
M8 plain washer
M8 spring washer
7 Confirm that the LCD Monitor is mounted securely, and then remove the hooks of the hoisting device.
- 2 - | - 3 - |
