U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S

Unpacking and Examining Your Oven

1.Remove all packing materials from inside the oven cavity. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right cavity wall. Read enclosures and SAVE the Operation Manual.

2. Remove the feature sticker, if there is one, from the outside of

the door.

Check the oven for any

damage, such as misaligned or bent door, damaged door seals

and sealing surfaces,

broken or loose door

hinges and latches

and dents inside the cavity or on the door.

If there is any damage, do not operate the oven and contact your dealer or SHARP AUTHORIZED SER-

VICER.

Choosing a Location for Your Oven

You will use the oven frequently so plan its location for ease of use. It's wise, if possible, to have counter space on at least one side of the oven. Allow at least 2 inches on the sides, top and at the rear of the oven for air circula- tion. Do not place or install the oven in any area where heat and steam are generated; for example, next to or above a conventional gas or electric range or above a conventional wall oven. Heat and steam may damage the electronics or the mechanical parts of the oven.

Built-in Kit

Your oven can be built into a cabinet or wall—not near or above a heat source—using Sharp’s white Built-In Kit RK-40W24 for R-402JW, black RK-40K24 for R-402JK or R-403KKorstainlesssteelRK-40S24forR-405KS.Ifyourdealer does not stock the kit, it can be ordered directly from the Sharp Accessories and Supplies Center. Have your credit card number available and call toll-free: 1-800-237-4277for ordering the kit to be sent to your address.

The kit includes ducts, finish trim strips and easy-to- follow instructions for installation as well as the location of the power supply.

G R O U N D I N G I N S T R U C T I O N S

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of electric shock by providing an escape wire for the electric current.

WARNING – Improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more

Permanent and Correct Installation

 

protected electrical supply. It is recommended that a separate circuit serving

3-Prong Plug

only this appliance be provided.

 

The oven is equipped with a 3-prong grounding plug. It must be plugged into a

 

wall receptacle that is properly installed and grounded. Should you only have a

 

2-prong outlet, have a qualified electrician install a correct wall receptacle.

 

A 3-prong adapter may be purchased and used temporarily if local codes allow.

 

Follow package directions.

3-Prong Receptacle

A short power-supply cord is provided to reduce risk of becoming entangled in

Ground

or tripping over a longer cord.

Receptacle Box

 

Extension Cord

 

If it is necessary to use an extension cord, use only a 3-wire extension cord that

 

has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug

Ground

on the microwave oven. The marked rating of the extension cord should be AC

Receptacle Box

 

115-120 volt, 15 amp. or more.

 

Be careful not to drape the cord over the countertop or table where it can be pulled on by children or tripped over accidentally.

Notes:

1. If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service person.

2.Neither Sharp nor the dealer can accept any liability for damage to the oven

or personal injury resulting from failure to observe the correct electrical connection procedures.

Radio or TV Interference

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and signal of receiving antenna.

5