10 OVEN INSTALLATION
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT REFERRING TO THE MOUNTING INSTRUCTIONS FOUND ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON BOTH TOP CABINET AND WALL TEMPLATES.
MOUNTING PLATE
1.Separate 4 Toggle Bolts 2, packed in the INSTALLATION HARDWARE, from the Toggle Nuts.
2.Use Wood Screws 1 to attach Mounting Plate to the stud or studs. Use Toggle Bolts to attach Mounting Plate through the holes at A, B, C and D; UNLESS THOSE HOLES ARE LOCATED ON THE STUD. Insert one Toggle Bolt into A, B, C and D where appropriate (these correspond to the holes of the Wall Template) and put the Toggle Nuts onto the Toggle Bolts. Figure 18.
Refer to instructions in Wall Template.
3.Position the Mounting Plate with the Toggle Bolts attached at the wall location and insert Toggle Nuts and Bolts through the holes in the wall with the Toggle Nuts closed. Figure 19. Use Wood Screws 1 to attach the Mounting Plate to studs.
NOTE: Before insertion, be sure you leave a space more than the thickness of the wall between the Mounting Plate and the end of each of the Toggle Nuts (in the closed position). If you do not leave enough space, the Toggle Nut will not be able to open on the other side of the wall. Also, once a Toggle Nut opens, it cannot be withdrawn from the hole; therefore make sure all of the Toggles are in the correct position before insertion.
4.Align the Mounting Plate carefully and hold in position while tightening Toggle Bolts. Pull Toggle Bolt toward you and turn clockwise to tighten. Figure 20.
Space more than wall thickness
Mounting 
Plate
Figure 18 | Figure 19 |
Wall
Figure 20
MOUNTING OVEN TO THE WALL |
| |
Two people are recommended to attach the Microwave |
| |
Oven/Hood to the Mounting Plate. |
| |
1. | Place cut portion of carton (B) on top surface of range. | (B) |
| ||
| Protection of the range cooking surface is recommended. A |
|
| protective drop cloth may also be used to cover the top of |
|
| the range. |
|
2. | Place carton portion (C) on portion (A); then place oven as |
|
| shown in Figure 21. |
|
3. | Place the oven and the carton portions together on the top |
|
| of the range covered with (B). Slide carton portion (A) | (C) |
| toward backsplash until stops. Align the lower back edge of | (A) |
| the oven with the mounting plate. |
|
Figure 21
6