E-15
ENGLISH
SD-PX2
Preparation for Use
- Setting the clock -
Setting the clock
By setting the unit to the correct time, you can use it not only as a clock but also for
timer playbac k.
In this example, the clock is set to 9:30 AM.
To confirm the time display:
[When the unit is in the stand-by mode]
Set the MODE 1/MODE 2 switch to MODE 1 and press the DISPLAY button.
The time display will appear for about 5 seconds.
[When the power is on]
Set the MODE 1/MODE 2 switch to MODE 2 and press the TIMER/SLEEP button.
Within 10 seconds, press the or button to select "CLOCK".
The time display will appear for about 10 seconds.
To readjust the clock:
Perform "Setting the clock" from the beginning.
zIn step 2, the time will be displayed.
zFollow steps 3 - 4.
Note:
Unplugging the unit or power f ailure will clear the clock setting.
Readjust the clock.
1Turn on the po wer, set the MOD E 1/MOD E 2 switch to MODE 2 an d
press the TIMER/SLEEP button.
2Within 10 seconds, press the or
button to select "CLOCK ADJUST",
and then press the ENTER button.
3Press the or button to adjust the
hour and then press the ENTER but-
ton.
zPress the or button once to advance the time by 1 hour. Hold it down to
advance continuously.
zThe 12-hour display will appear.
z"AM" will change to "PM" automatically.
4Press the or button to adjust the
minutes and then press the ENTER
button.
zPress the or button once to advance the time by 1 minute. Hold it down
to advance continuously.
zThe hour will not advance even if minutes advance from "59" to "00".
zThe clock starts from "0" second (seconds are not displayed).
zThe time disappears after approx. 2 seconds.