E-59
ENGLISH
SD-PX2
References
- Troubleshooting chart -
Troubleshooting chart
Many potential prob lems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the fol lowing before calling y our autho-
rized SHARP dealer or service center.
General
Tuner
Remote control
Symptom Possible cause Reference
page
No sound is heard. zIs the volume level set to "0"? P. 16
zAre the headphones connected? P. 55
zAre the speaker wires disconnect-
ed? P. 11
The sounds from speakers
are not well balanced. zAre the speaker wires connected to
the wrong channels? P. 11
Noise is heard during play-
back. zMove the unit away from any com-
puters or mobile phones.
When a button is pressed,
the unit does not respond. zSet this unit to the power stand-by
mode and then turn it back on. If the
unit still malfunctions, reset it.
P. 60
Interference or noise occurs
on the TV image. zIs the unit placed near TV with inter-
nal antenna? Use an outdoor anten-
na.
P. 12
Timer playback does not
start. zDid you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock and timer.
P. 15, 48
"CLOCK ADJUST" appears
when checking the clock. zDid you remove the plug from the
AC outlet, or did a power failure oc-
cur? Reset the clock.
P. 15
The display on the unit is
dark. zIs the display in the dimmer mode? P. 16
The display does not appear. zIs the sliding door open? P. 17
The power is not turned on. zIs the unit unplugged? P. 14
No images are displayed. zIs TV turned on? P. 51
zIs the input of TV switched? P. 51
Symptom Possible cause Reference
page
The radio makes unusual
noises continuously. zIs the unit placed near the TV or
computer?
zIs the FM antenna or AM loop anten-
na placed properly? Move the an-
tenna away from the AC power cord
or the unit if located near.
P. 12
The preset channel cannot
be recalled. zDid you remov e the plug from the
AC outlet, or did a power failure oc-
cur?
P. 34
Preset the channel again.
Symptom Possible cause Reference
page
The remote control does not
operate properly. zIs the battery polarity respected? P. 14
zAre the batteries dead?
zIs the distance or angle incorrect? P. 14
zAre there any obstructions in front of
the unit?
zIs the remote control sensor ex-
posed to strong light (inverter fluo-
rescent light, direct sunlight, etc.)?
P. 14
zIs the remote control for another
equipment used simultaneously?
The unit cannot be turned on
with the remote control. zIs the AC power cord of the unit
plugged in? P. 14
zAre the batteries inserted? P. 14