Sharp SJ-GJ584V operation manual Installation, When transporting, Before using your refrigerator

Models: SJ-GJ584V

1 12
Download 12 pages 9.97 Kb
Page 5
Image 5
INSTALLATION

INSTALLATION

Free standing type

WARNING

Do not install the refrigerator in a damp or wet location as this may cause damage to the insulation and create a leak. Condensation may also build on the outer cabinet and cause rust.

1

Keep adequate ventilation space around the refrigerator.

• The figure shows the minimum

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

90mm

 

 

required space for installing the

 

 

 

 

 

 

 

 

or more

 

 

 

 

 

 

 

 

 

 

 

refrigerator.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The amount of space

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

around the refrigerator

 

60mm

 

 

 

 

 

 

 

 

 

 

or more

 

 

 

 

 

 

 

 

 

 

affects the amount of power

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

consumption.

 

 

 

 

 

 

 

 

 

 

 

 

60mm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• Insufficient spacing will decrease

 

 

 

 

 

 

 

or more

 

 

 

 

 

 

 

 

 

 

 

cooling efficiency and increase

 

 

 

 

 

 

 

 

 

 

 

 

 

 

energy consumption.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This may reduce the life of the unit and void warranty.

If using the refrigerator in the smaller space dimension than the below figure, it may cause the temperature rise in the unit, loud noise and failure.

The space between the rear of the refrigerator and the wall should be 60mm or more and less than 75mm.

If the space is wider than 75mm, you may get injured by touching compressor and its peripheral parts which are extremely hot during the operation.

Overall space required in use mm1525

1400 mm

4 Connect the power plug to a 230/240 volt. 10 amp. power point.

NOTE

Position your refrigerator so that the plug is accessible.

Keep your refrigerator out of direct sunlight.

Do not place next to heat generating appliance.

Do not place directly on the ground. Provide suitable stand.

If the mains power is switched on when the door is open, the door alarm will sound. Close the door to stop the alarm.

When transporting

The casters allow the refrigerator to move back and forth.

Carry the refrigerator by holding the handles located on the rear and the bottom.

rearbottom

Casters (4 pcs.)

Before using your refrigerator

Clean the inside parts with a cloth soaked in warm water.

If soapy water is used, wipe it off thoroughly with water.

2 Use the two front adjustable feet, to ensure that the refrigerator is positioned firmly and flat on the floor.

When transporting Adjustable foot

3 Remove the 2 screws of the cabinet lower part, and then set the foot cover (supplied inside the refrigerator compartment) with removed 2 screws.

Foot cover

Screw

(2 screws)

5

Page 5
Image 5
Sharp SJ-GJ584V operation manual Installation, When transporting, Before using your refrigerator