Controlling the Projector by a Computer

Controlling theProjector Using anRS-232C Cable

When the RS-232C terminal on the projector is connected to a computer with an RS-232C cable (null modem, cross type, commercially available), the computer can be used to control the projector and check the status of the projector. See page 65 for details.

1 Connect an RS-232C cable to the projector.2 Connect the above cable to the computer.

Note

•Do not connect or disconnect an RS-232C cable to or from the computer while it is on. This may damage your computer.

•The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details.

•Refer to “Computer Compatibility Chart” on page 66 for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.

To RS-232C terminal

RS-232C cable (commercially available)

To RS-232C terminal

and Connections Setup

Desktop computer

-23

XV_Z200U_E_p13_28.p65

23

03.10.21, 4:09 PM