34
Image Projection (Continued)
ROn-screen display
GEOMETRIC ADJUSTMENT
Geometric Adjustment
2
Press c KEYSTONE on the re-
mote control repeatedly until
“GEOMETRIC ADJUSTMENT” is
displayed.
3Press P, R, O or Q to move the
position for the upper left of the
image.
•Adjust the screen until the displayed red
arrows line up in the upper left.
4Press i ENTER to set the posi-
tion.
•The arrow in the upper right turns red.
5Repeat the same procedure with
the positions for the upper right,
lower right and lower left of the
image.
•When you press e RETURN at this point,
you will return to the previous screen.
•If you press e RETURN before adjust-
ing the upper left corner, the Reset Con-
firmation screen displays.
•When you confirm the lower left posi-
tion, the screen adjustments will be set
and the “GEOMETRIC ADJUSTMENT”
mode will end.
1
Adjust the focus, size, and projec-
tion angle so that the screen
edges line up into the blue area.
•Line up the screen edges into the blue
area as closely as possible.
Adjust upper left corner
GEOMETRIC ADJUSTMENT
ADJUST
NEXT
RESET
END
•The placement of the screen and the projector
may result in the image aspect ratio becoming
slightly distorted.
•Try “H&V KEYSTONE” when “GEOMETRIC
ADJUSTMENT” does not fully correct trapezoi-
dal distortion.
Note
Blue
area Screen Upper Left Upper Right
Lower Left Lower Right
•When adjusting a 4:3-aspect-ratio input sig-
nal to a 4:3-aspect-ratio screen, correct the
trapezoidal distortion by setting “RESIZE” to
“STRETCH” (16:9).
Info
XV-Z3000_EN_h 06.2.9, 10:58 AM34