Appendix
57

Removing and Installing the

Lamp Unit

• Make sure that you remove the lamp unit by
the handle. Do not touch the glass surface of
the lamp unit or the inside of the projector.
• To avoid injury to yourself and damage to the
lamp, make sure you carefully follow the steps
below.
• Do not loosen other screws except for the
lamp unit cover and lamp unit.

Press SSTANDBY/ON on the pro-

jector or aSTANDBY on the re-

mote control to put the projector

into standby mode.

•Wait until the cooling fan stops.
Warning!
• The lamp unit becomes very hot while the pro-
jector is operating. Do not remove the lamp
unit from the projector right after use. The lamp
and parts around the lamp will be very hot and
may cause burns or injury.

Disconnect the power cord.

•Unplug the power cord from the AC
socket.
•Leave the lamp until it has fully cooled
down (about 1 hour).

Remove the lamp unit cover.

•Turn the projector over. Loosen the user
service screw (1) that secures the lamp
unit cover. Remove the lamp unit cover
(2).
1
2
Lamp unit
AN-XR10L2
Info
Optional
accessory
AC socket
User service screw
(for lamp unit cover)
1
2
3
STANDBY/ON button
XV-Z3100_EN_l 06.10.18, 7:35 AM57