ENGLISH
POWER SWITCH
Push this switch to enter the standby mode.
To switch the power off, push again this switch.
STANDBY INDICATOR
POWER BUTTON
In the standby mode, press this button to turn the power on, then the STANDBY indicator goes off.
Press again this button to turn the power off, then the STANDBY indicator lights up.
HEADPHONE JACK
Stereo headphones with a standard 1/4 inch plug can be plugged into this jack for private listening.
SPEAKER A, B SELECTOR BUTTONS
These buttons allow you to select various combinations of speakers as follows:
To drive A speakers, press only the SPEAKER A button (“SPEAKER A” lights up).
To drive B speakers, press only the SPEAKER B button (“SPEAKER B” lights up).
To drive both A and B speakers, press the SPEAKER A and B buttons (“SPEAKER A” and “B” light up). When using headphones for private listening, press these buttons to switch off the speaker A and B (“SPEAKER A” and “B” go off).
INPUT SELECTOR BUTTONS
Press the button to select the desired input source.
TONE BUTTON
When adjusting the tone (bass and treble), press this button to select the desired tone mode.
Each time this button is pressed, the tone mode is changed to bass or treble.
BALANCE BUTTON
When adjusting the sound volume balance, press this button to enter the balance mode.
BALANCE, TREBLE/BASS UP/DOWN
( | , / ) BUTTONS |
At the balance mode, adjust the sound volume balance between left and right speakers with these buttons. When the BALANCE / buttons on the remote control are pressed, it enters the balance mode automatically without pressing the BALANCE button on the front panel.
At the desired tone mode, adjust the tone as desired with these buttons.
TONE DIRECT BUTTON
Press this button to listen to a program source without the tone effect.
VOLUME CONTROL KNOB, UP/DOWN( / ) BUTTONS
Adjust the volume to a comfortable listening level with this knob or these buttons.
MUTE BUTTON
Press this button to temporarily mute the sound. Press again to resume the previous sound level.
DISPLAY BUTTON
Press this button to select the brightness of the fluorescent displays as desired.
Each time this button is pressed, the brightness of all fluorescent displays of Sherwood components connected by the DIGI LINK III changes together as follows:
ON dim OFF
SLEEP BUTTON
Press this button to activate the sleep timer for a specified period of time.
Each time this button is pressed, the sleep time changes as follows:
10 20 30 60 90 OFF Unit : minutes
REMOTE SENSOR
This receives the signals from the remote control unit.
FLUORESCENT DISPLAY
For details, see the next page.
8
