Sherwood RX-4105 manual Tuning to preset stations, Listening to FM stereo broadcasts

3	Select the desired preset number (1~30)	4	Repeat the above steps 1 to 3 to
	and press the MEMORY button.		memorize other stations.

	MEMORY BACKUP FUNCTION
• When using the NUMERIC buttons on the remote	The following items, set before the receiver is turned
control.	off, are memorized.
Examples) For “3” :	• INPUT SELECTOR settings
For “15” :	• Preset stations,etc.
	Note
For “30” :	• If the electricity fails or the AC input cord is
• The station has now been stored in the memory.	disconnected for more than several days, they are
• When using the NUMERIC buttons, the station is	all cleared. So you should memorize them again.
stored automatically without pressing the MEMORY
button.

•A stored frequency is erased from the memory by storing another frequency in its place.

•If “MEMO” goes off, start again from the above step 2.

Tuning to preset stations		Select the desired preset number.
		2
1	After selecting the tuner as an input
	source, select the preset mode.
		• When using the NUMERIC buttons on the remote
		control.
		Examples) For “3” :
		For “15” :
• Then “PRESET” lights up.		For “30” :
		• When selecting the desired preset number with the
		NUMERIC buttons, the desired preset station will be
		tuned to automatically without selecting the preset
		mode.
Listening to FM stereo broadcasts		Scanning preset stations in sequence
• While listening to FM broadcasts,

• Each time this button is pressed, the FM mode changes as follows:

• When FM stereo broadcasts are poor because of	• The receiver will start scanning the stations in the
	preset sequence.
weak broadcast signals, select the FM mono mode
	• At the desired station, press this button again to stop
to reduce the noise, then FM broadcasts are
	scanning.
reproduced in monaural sound.

13