4.Feed control knob/wire through the T-handle until spring touches the round hole. CAUTION: Do Not Compress Spring At This Time. Feed wire through the square handle tube. Be sure wire passes above the bolts in the handle brace. Secure T-handle to the tube with (1) 1/4-20 x 2” hex bolt. (2) washers, and (1) hex nut in the bottom hole, and (1) 1/4-20 x 2 1/4” hex bolt, (2) washers, and (1) hex nut in the top hole as shown. Remove caution label and push the thumb release toward the center and push down knob and shutoff spring until knob latches.
Wire Clip
Wire
Shutoff Plate
Remove Caution | Control Knob & |
Label | Wire Assembly |
Thumb | Spring |
Release | |
1/4-20 x
2 1/4” Bolt & Washer
1/4-20 Hex Nut & Washer
CAUTION: ONCE KNOB IS LATCHED, DO
NOT MOVE THUMB RELEASE UNTIL YOU
HAVE COMPLETED STEP #5.
5.Slide wire retaining clip onto wire as shown. Insert wire through hole shutoff plate. Slide wire retaining clip over shutoff plate and wire until the clip locks into place.
6.Install gear cover assembly over gears and secure with (2) #6-32 screws. The 41RS spreader should now be com- pletely assembled and ready for use. Slide handle grips onto handle. Soapy water will ease installation. (Do not use petroleum based products.)
