Shoprider PHFW-1018, PHFW-1020 manual FPC-11 Battery Installation PHFW-1118/PHFW-1120

FPC-11 BATTERY INSTALLATION (PHFW-1118/PHFW-1120)

Battery Baskets

U-1 Batteries

Battery Lids w/ Cables

Using the two 10mm wrenches, bolt the battery cables to battery terminals.

*MATCH COLORS ACCORDINGLY!*

Battery Basket Supports

2-10mm Box /Open-End Wrenches

Battery Strap w/ Buckle

Battery Strap w/o Buckle

Once all batteries cables	Place each assembled battery into
are attached securely…	each battery basket. Secure the
	battery to the basket using the
	battery strap w/ the buckle and
	tighten securely.

…Secure each lid using the strap w/o the buckle.

1) Be sure the Powerchair is fully open. From the front

		of the unit push down on the right and left seat
		edges. If necessary, from the back of the unit finish
		opening the unit by pushing the battery basket
		supports outwards until the gap is wide enough for
		the battery baskets to slide into the supports. You
		can see that the unit is fully open by looking at the
		drive wheels, verifying that they are perfectly vertical
		(straight up and down) and not slanted.
		2) Slide the battery basket with the black connector in
		first and connect the black battery connector to the
		black connector secured to the left front part of the
		frame. Next, slide the battery basket with the red
		connector in and connect to the red connector
		secured to the left rear part of the frame.
6/25/2004	21	3) Make sure to charge battery fully for 6-8 hours before
		first initial use