CONNECTING THE HARDWARE ADAPTER TO THE DFR11EQ
Once the switch assembly and hardware adapter are connected, plug the hardware adapter of the
DFR11EQ BACK PANEL
HARDWARE ADAPTER
CONNECTING THE HARDWARE ADAPTER
FIGURE 3
MOUNTING THE DRS-10 SWITCH ASSEMBLY TO A WALL
The switching assembly of the
1.Mount a standard electrical box into the wall.
2.Place the position ring onto the switch assembly, fitting the tab of the ring into the desired numbered groove on the switch assembly.
NOTE: The switch assembly of the
3.Peel the plastic sheath from the affixed labels on the wall plate and hardware adapter. A second
4.Insert the switch assembly post through the lock washer and wall plate and attach with the supplied washer and nut, being careful not to
5.Press the supplied knob onto the switch assembly post.
6.Secure the wire cable to the switch assembly using the two screw terminals on the back of the assembly, as previously described in Figure 1.
7.Mount the assembly to the electrical box in the wall.
WALL PLATE 
LABEL
SWITCH ASSEMBLY
WASHER | POSITION RING |
NUT | LOCK WASHER |
KNOB |
|
FIGURE 4
SPECIFICATIONS
Connectors
DFR11EQ connection: Male
Cable connection: Screw terminals
Case
Plastic housing
Dimensions
Hardware Adapter: 6.3 cm L x 3.3 cm W x 1.6 cm H (2.5 in. L x 1.3 in. W x .65 in. H)
Mounting Assembly: 12 cm H x 7.4 cm W x 4.7 cm D (4.75 in. H x 2.94 in. W x 1.87 in. D)
Cable
Maximum Resistance: 100 ohms series between switch and hardware adapter
Maximum Length: at least 914 m (3,000 ft.)
Certification
Tested to comply with FCC standards. FOR HOME OR OFFICE USE. This product complies with part 15 of the FCC rules. Operation is subject to the following two condi- tions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate this equip- ment.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to ra- dio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tele- vision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and the receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is con- nected
Consult the dealer or an experienced radio/TV tech- nician for help
This class B digital apparatus complies with Canadian
Conforms to European EMC Directive 89/336/EEC: Pro- fessional Audio Products Standard EN 55103 (1996); Part 1 (emissions) and Part 2 (immunity). The
Replacement Parts
Hardware Adapter Kit . . . . . . . . . . . . . . . . . . . . . RPC601
Switch Assembly Kit . . . . . . . . . . . . . . . . . . . . . . RPC603
Wall Plate Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . RPC602
2
