SE210
Sound Isolating™ Earphones
Combining
ideal portable listening device upgrade. An included modular cable and interchangeable Sound
Isolating™ sleeves provide a comfortable, personalized fit.
The carrying case further enhances the portability of these lightweight
earphones.
WEARING THE EARPHONES
Three suggested methods for wearing the earphones are illustrated below.
Over the ear
in back
Over the ear
in front
Straight down
in front
Cable
Sleeve
EARPHONESTHEINSERTING | If the earphone seems to be lacking in low frequency response (bass), | |
check the tightness of the seal between the earphone and your ear, or | ||
| ||
| try one of the other sleeve options. |
Warning: Do not push the earphone sleeve beyond the ear canal opening.
To replace sleeve, carefully remove old one and slide new sleeve over nozzle barb. If any part of the nozzle is exposed, sleeve is not properly installed.
Replace sleeves if they do not grip the nozzle tightly
©2006, Shure Incorporated 27EN3243 (Rev. 2)
Printed in U.S.A.
Tighten the cable and take up slack by raising the cable sleeve. | Nozzle Barb | Sleeve | Sleeve Over Barb |
| Grasp the body of earphone and gently twist to remove. |
REMOVING THE EARPHONES | CHOOSING AN EARPHONESLEEVE |
Note: Do not pull on cable to remove earphone.
Your earphones come with a selection of sleeves. Make sure the sleeve | NOZZLE | If you notice a change in sound quality, remove the sleeve and check | |
you choose is easy to insert into your ear, fits comfortably, and is easy | the nozzle of your earphone. If nozzle is blocked, clear obstruction by | ||
to remove from your ear. | using wire loop end of cleaning tool. | ||
|
| ||
Soft Flex Sleeves | THE EARPHONE |
| |
In small, medium, and large sizes. |
| ||
Made from pliable rubber. |
| ||
|
| ||
Soft Foam Sleeves | CLEANING |
| |
When using the foam sleeves, compress the sleeve | Wire Loop | ||
between your fingers before inserting it into the ear canal. | |||
| |||
Hold the earphone in place for about ten seconds while the |
| ||
foam expands and creates a tight seal. | Nozzle | ||
|
| ||
|
| Cleaning | |
| Tool | ||
If desired, the sleeve stem may be shortened. Use sharp |
| ||
|
| ||
scissors to carefully trim the stem to the desired length. |
|
| |
Note: carefully slide sleeve over earphone nozzle barb for a secure grip. |
| When cleaning, do not force any object through the earphone | |
|
| ||
|
| nozzle! This will damage the earphone sound filter. |
