TC12 Installation, Commissioning & Maintenance Handbook
(1) Before starting th
should be configur
appropriate.
the TC12 So
Installation softwar
short time followed
should look somet
ftware is Version
that the sta
for possible display messages and actions).
n has locked up altogether and does not respond to
Ram address switches are set up correctly on each
e to the
in the PC from the
options on the 'Ethernet card' menu. (If an on-bard Ethernet connection is
s
n
O
d
T
is
) On Version 8.3 Software, move to the ‘Comms’ menu and select one of the
following options:
onal leased line is being used to connect
If direct Instation to outstation, RS232,
trol.
e status of the IMD cards shown in the IMD Cards box. Correctly
installed cards will be shown as ‘OK’ together with 2 numbers separated by
a ‘/’. The first number is the address of the board and the second number
r of the board. Also shown will be the type of IMD board
e TC12 software installation the Ethernet connection
ed using the instructions given in 2.2.2.5 or 2.2.2.6, as
(2) Insert ftware disk into the PC and then switch the PC On. The
e will auto-boot and 'SIEMENS' will be displayed for a
by the TC12 Instation PC Installation Screen, which
hing like Figure 4 if the software is Version 7.4. If the
mething like Figure 5. so 8.3 it should so
(3) Check tus for each IMD board is correctly indicated (see below
If the Installation scree
key presses check the
card (see section 2.2.2.8). If the switches are set correctly chang
next available address as indicated in 2.2.2.8.1 and restart the installation.
(4) Follow the instructions displayed for moving around the screen.
(5) Select the type of Ethernet card that was installed
being used, select the ‘Panel PC (UM9008)’ option.) On Version 7.4
oftware, move across to the 'Number of boards' menu and enter the
umber of Ethernet cards that are installed in the PC - normally 1.
(6) n version 8.3 Software, move to the ‘Tune’ menu and select YES or NO,
epending upon whether or not you wish the tune to be played when the
C12 PC boots up. Move across to the 'SIP' menu and select YES if a SIP
installed in the TC12 cabinet, otherwise select NO.
(7
Modem If a conventi
the Instation to the OTUs.
Direct/Flow Control communications are being used with CTS/RTS
flow control.
Direct/No Flow Cntrl If direct Instation to outstation, RS232,
communications are being used without
CTS/RTS flow con
(8) Check the status of the DIGI I/O cards shown in the Digital I/O box.
Correctly installed cards will show as ‘OK’, cards which are not installed will
show as ‘Not installed’ and cards which are incorrectly installed will show an
error message which may give a clue as to the nature of the problem.
(9) Check th
the IRQ numbe
which has been detected, either ‘Xi or Xe’ or ‘Xem’. Any boards which have
not been detected by the software will be shown as ‘Not detected’.
666/HE/43100/000 Page 20 Issue 9