TC12 Installation, Commissioning & Maintenance Handbook
(10) If the indications for the DIGI I/O and IMD cards are as expected, move
across to the nd hit return. The TC12
Software wil e PC. Should the DIGI
I/O cards and/or IMD cards not be shown as expected then choose the
‘Quit’ option and correct the problem.
(11) Exit the Installation software. Eject the TC12 Software disk and keep this as
2 cabinet.
2.2.
ed
correctly in PC slot, check switch settings of Port address
Digi I/O cards (see section
heck Ram address switches set up
e section 2.2.2.8).
Switches set correctly - change to next available address
).
2.2.2
he PC is accessible from the back of the Instation. It is placed on the PC
ounting chassis (6 of the Instation.
ication
he
Master switch Panel assemb
e the possibility of the cables chafing against the
m D card in the PC, care should be taken to
IMD cables chafing on the solder side of
jacent PC possible the IMD PCBs should be located
en the IMD cables and adjacent PCBs.
'Install' menu, select the 'Yes' option a
l now be installed on the Hard disk of th
a backup.
(12) Disconnect the PC from the mains and disconnect the monitor. The PC can
now be installed in the TC1
2.11.1 Error Messages during TC12 Instation PC Software Installation
Messages and Errors that may be displayed on the 'Digital I/O boards' and 'IMD
boards' status menus during the software installation and suggested corrective
actions are shown below:
Displayed Message Action to be taken
OK None - Card installed OK
Not Installed None unless card should be present; check card is insert
for IMD cards or address for
2.2.2.7 or 2.2.2.8).
Ram Error IMD cards only - c
correctly on card (se
as indicated in 2.2.2.8and restart installation.
Switches set incorrectly - correct and restart installation.
Faulty Replace card.
Int. Failed Check Interrupts set up correctly on the card (see2.2.2.8
.12 PC Mounting Chassis
T
m 67/2/22621/000), which is a shelf at the top
The PC is not visible from the front of the Instation as the System Fault Ind
Panel is fitted across the fron ocket on tt. The PC mains lead plugs into a s
ly at the back of the Instation.
Note: Lengths of 'U' channel (e.g. 915/4/03641/000) should be cut and placed
along the edges of the cut-outs in the back of the PC through which cables
pass, in order to eliminat
edges.
there isIf ore than one IM
avoid the possibility of the
isad Bs. As far as
such that a spare slot exists betwe
666/HE/43100/000 Page 21 Issue 9