Silex technology SX-SDWAG Chapter Installation, Installation Requirements, Installation Procedure

Chapter 3

Installation

Installation Requirements

The SX-SDWAG must be installed in a device that contains a 9-pin SDIO slot.

The SX-SDWAG has FCC modular approval, which can eliminate the need for you obtain FCC Part 15 Subpart C and E (intentional radiation) approvals for your device. In order to use this FCC modular approval for the SX-SDWAG, you must:

1.Include “Contains FCC ID: N6C-SXSDWAG” on the label of your device.

2.Use the Silex dipole antenna (refer to appendix A) or an equivalent dipole antenna with equal or lower gain.

3.Use the special Silex antenna cable (includes ferrites for additional EMI suppression; refer to Appendix A)

If you do not follow the above instructions, then it is your responsibility to obtain the necessary FCC approvals.

Installation Procedure

To install the SX-SDWAG:

1.Be sure to use the proper antistatic handling techniques.

2.Insert the SX-SDWAG into an available SDIO slot in your device. Make sure that it is securely seated.

3.Connect one end of the antenna cable to the main antenna connector on the SX-SDWAG (see figure 2). If you are using a diversity antenna configuration, connect one end of the second antenna cable to the secondary antenna on the SX-SDWAG.

Installation

Silex

Revision A-2

Page 9