•Should steam collect on or around the outside of the appliance door, wipe it off with a soft towel. This can happen if the microwave is operated in extremely humid conditions.
•Clean the turntable 3 regularly. Clean the plate in warm soapy water or in the dishwasher.
•Clean the grill stand t in warm dishwater and dry it well.
•Regularly eliminate odours. Place a deep micro- wave bowl with a cup of water and the juice and peel of a lemon into the microwave oven. Heat it up for 5 minutes. Wipe off thoroughly and rub dry with a cloth.
•Should replacement of the bulb in the micro- wave be necessary, arrange for it to be ex- changed by a dealer or consult our Service Department.
Troubleshooting
The display 1 indicates nothing.
•The plug is not inserted into a power socket. Check the plug.
•The mains power socket is defective. Try another mains power socket.
•The display 1 is defective. Contact our Customer Services Department.
The appliance does not respond to pressing the buttons.
•The Child safety facility is activated. Deactivate the Child safety facility (see chapter "Operation“).
The appliance does not start the cooking/ warming process.
•The door is not properly closed. Close the door correctly.
The turntable 3 generates loud noise when revolving.
•The turntable 3 is not correctly positioned on the axle. Insert the turntable 3 correctly into the cooking area.
•The small rollers 4 and/or the floor of the cooking area are unclean. Clean the rollers 4 and the floor of the cooking area.
The display 1 indicates "E01" and signal tones sound.
•The microwave is overheated. Terminate the current programme immediately. Remove the plug from the mains power socket, open the microwave door and allow the appliance to cool down.
The display 1 indicates "E02" and signal tones sound.
•There is an error on the sensor. Interrupt the programme and let the appliance cool down. Then restart the microwave. If the error occurs again, contact Customer Support.
•There is an error during the heating up of the appliance. Interrupt the programme and let the appliance cool down. Then restart the micro- wave. If the error occurs again, contact Customer Support.
The display 1 indicates "E03" and signal tones sound.
•Due to a short circuit or open circuit voltage, the microwave has switched into fault protection. Stop the programme and remove the power plug. If possible, eliminate the problem, e.g. metals in the cooking area, which can lead to the above problem when using the microwave function. Otherwise, please contact our Customer Support.
- 23 -
