➩Fill the mixer attachment e with 750 ml of wa- ter and add a few drops of mild detergent. Clo- se the lid (2) and place the mixer attachment e on the motor block u. Insert the plug into a mains power socket and activate the Ice Crush/Clean switch, causing the cutters to rotate in the water with maximum revolutions. Afterwards, rinse the mixer attachment e with lots of clean water, such that all soap residues are removed.
Should this not dislodge the soiling, you can separate the lower plastic part of the mixer jug e (with the cut- ters r) from the the glass part:
e back onto the glass part of the mixer at- tachment e and screw it tight. Ensure that the se-
aling ring | is correctly fitted. |
Cleaning the motor block
➩Use a dry cloth or, at the most, a lightly moistened one for cleaning the plastic surfaces.
➩At every cleaning check that the contact switch in the receptor for the mixer jug e is not blok- ked by soiling residues. If you cannot dislodge any blockages with the corner of a piece of pa- per, make contact with Customer Services. Un- der no circumstances should you use a hard ob- ject, this could damage the contact switch.
➩Remove any possible residues on the underside of the motor block u only with a dry cloth or a stiff bristled brush. Ensure that nothing can enter through the ventilation opening of the appliance.
After cleaning
Allow all parts to dry well before
Storage
➩Remove the mixer jug e from the motor block
u.
➩ Turn the plastic element of the mixer attach- ment e
Attention!
Take care with the cutters . They are very sharp. Risk of injury!
➩Clean both parts thoroughly in a mild soapy solution or in a dishwasher.
➩ Place the plastic part | of the mixer attachment |
➩If you do not intend to use the liquidiser for an extended period, clean it thoroughly (see chapter "Cleaning").
➩Wrap the power cable y around the cable sto- rage i on the base of the motor block u.
➩Store the liquidiser at a cool and dry location.
- 6 -
