Silvercrest SZP25A1-07 manual Juice extraction, Emptying, Disassembly

Juice extraction Emptying

Note:

When pressing out juice, do not exceed the 600 ml volume marking on the scale of the juice collector

u.

1.Adjust the fruit pulp regulator t, by sliding it, so that the slits in the fruit pulp sieve r/y lie exactly above each other if you wish to have fru- it juice with fruit pulp. Adjust the fruit pulp regula- tor t , by sliding it, so that the slits in the fruit pulp sieve r/y are not lying above each other if you do not wish to have fruit juice with fruit pulp.

2.Cut the fruits in half (orange, lemon etc.)

3.Press the halved fruit lightly onto the squeezing cone w/e. The appliance switches itself on automatically as soon as the squeezing cone w/e is pressed down.

4.Apply pressure at various parts of the fruit rind with your fingers. Thereby the juice will be even- ly squeezed out of the fruit.

5.When no more juice flows from the fruit, stop applying pressure to the squeezing cone w/e. The appliance stops.

6.Press the squeezing cone w/e down repeated- ly to loosen it, until it turns in the opposite direction.

7.When no more juice flows from the fruit, stop applying pressure to the squeezing cone w/e. The appliance stops. Remove the fruit skin from the squeezing cone w/e.

8.Continue similarly with further fruit-halves until you have squeezed out the desired volume of fruit juice. The current volume squeezed can be read off from the scale on the side of the juice collector u.

Important:

Remove the power plug from the wall socket when you empty the fruit pulp sieve r/y or the juice collector u. Otherwise there is a risk that the appli- ance could start unintentionally.

•Turn the juice collector u anti-clock-wise until the perceptible resistance desists. You can now lift it from the drive axle i and pour the juice out.

Disassembly

If you wish to disassemble the Citrus Press, e.g. for the cleaning of it, proceed as follows:

1.Remove the power plug from the wall socket o.

2.Remove the squeezing cone w/e.

3.Remove the fruit pulp sieve r/y.

Press the hook on the underside of the upper fruit pulp sieve r inwards. At the same time exert light pressure on the fruit pulp sieve t. The com- ponents allow themselves to be pressed apart.

4.Turn the juice catchment container u anti- clockwise until the perceptible resistance diminishes. You can now lift it from the drive axle i.

- 4 -