Simaudio W-7m owner manual Specifications

MOON W-7m Mono Power Amplifier

Specifications

Configuration			Dual Mono
Power Supply Transformers			2 x 0.5kVA
Power Supply Capacitance		......................................	240,000µF
Class Of Operation			A/AB
Design			Fully Balanced Differential
Input Impedance			47,500Ω
Input Sensitivity			1780mV
Output Device Type			Bipolars - 24
Output Power at 8Ω			500 Watts
Output Power at 4Ω			1000 Watts
Frequency Response			10Hz - 200kHz +0/-3dB
Output Impedance			0.005Ω
Damping Factor (static)			1600
Gain	......................................................................		31dB
Signal-to-noise Ratio			> 106dB @ full power
Maximum Output Voltage		.......................................	60 Volts
Slew Rate			70V/µs
Maximum Current – Peak			68 amperes
Maximum Current – Continuous			32 amperes
Crosstalk @ 1kHz			Not applicable
Intermodulation Distortion		......................................	Unmeasureable
THD	(20Hz - 20kHz @ 1 watt)		< 0.015 %
THD	(20Hz - 20kHz @ 500 watts)		< 0.04 %
Power Consumption @ idle		.....................................	40 Watts
AC Power Requirements			120V / 60Hz or 240V / 50Hz
Shipping Weight			85 lbs	/ 38 Kgs
Dimensions (W x H x D, inches)			18.75 x 7.5 x 16.5
Balanced Pin Assignment: Pin 1			Ground
		Pin 2	Positive
		Pin 3	Negative
12 Volt Trigger:		Logic	Direct	(0V off, 12V on)
		Jack	3.5mm microphone jack
		Input Impedance	1kΩ
		Current Consumption	12mA

NOTE: In the event that you require the RS-232 codes for your MOON W-7m, please contact Simaudio Ltd. directly by either email (service@simaudio.com) or by toll-free telephone (877-980-2400).

Fuse Replacement:	For the 120V version use a 8A fast blow	(3AG size).
	For the 230V version use a 4A fast blow	(3AG size).

____________________________________________________________________________________

Specifications 10