Simplicity 14E manual Attaching the Hopper, Attaching Hopper to the Rotor

Attaching the Hopper

1.See Figure 4. Attach the hopper to the rotor hous- ing, using care to engage the metal lip of the hopper liner to the inside of the housing.

2.Secure the hopper to the rotor housing using (2) 5/16 x 1/2 hex head bolts and (2) 5/16 flat washers. Do not tighten hardware at this time.

3.See Figure 5. From the inside of the hopper, install

(1) 5/16-18 x 3/4 hex head bolt, 5/16 lockwasher, and 5/16 flat washer into each of the upper and lower holes of the metal hopper liner. Do not tighten at this time.

4.Make sure the hopper is properly seated on the rotor housing, and then tighten all hardware securely.

Assembling the Chipper/Shredder

Figure 4. Attaching Hopper to the Rotor

Figure 5. Installing Hardware Inside Hopper

9