Simplicity 319 manual Power STAKE-OFF Power T a K E O F F K I T

8

POWER STAKE-OFF

POWER T A K E - O F F K I T

Mfr’s. NO. 311

for

LANDLORD RIDING TRACTOR

For operation of Rotary Mower and Sickle Bar attach- +nts, a power take-off attachment is required. This consists of the power take-off assembly, “V” pulley for bevel gear shaft, drive belt, belt guard, and belt SLOP packaged in one carton.

For ease of attachment follow the step; outlined below.

1. Mount “V” pulley to shaft of bevel gear assemble

( see figure 1 ) and secure in place with key and set screw. Hub of “V” pulley is to face inward. Place drive belt on “V” pulley and mount belt guard support to.:

inside surface of side plate nearest drive pulley. See‘

figure 5 for mounting bolt location. Attach the ~belt. guard to the guard support as shown in figure 1. Allow approximately 3/16” clearance between belt and hard;:

B E L T G U A R D S U P P O R T

F i g . I

2.Holding the power take-off assembly in left hand as shown in fieure 2. oosition the tube of the drive bracket assembly b&&n the bevel gear housing side plates. Align the holes in side plates with the hole in drive bracket assembly tube and insert pivot pin through holes in side plates and drive

bracket assembly tube.

3.Push pivot pin through the holes in bracket and tube until the position of cotter pin hole in pivot pin is as shown in figure 3. Secure in position with

r \ .;;I-’

BEVEL GEAR HOUSING SIDE PlqT’

63.2

4.Remove hex cap screw “D” from frame oftractor and mount bracket in place under lift lever quadrant. See figure 4. Position the pivot bar assembly flush against bottom of lift quadrant and re-install hex cap screw and tighten,securely.’ Check alignment of drive pulley on bevel gear shaft, driven pulley of power takg-off, and idler pulley, and adjust driving p u l l e y i f n e c e s s a r y . ~,

SIDE PLATE

3RIVE B

cotter	pin furnished.	mg. J
..,	SIMPIJCITV MARUFACTURIW-G,,.CO,~-~,ANV	/ P O R T W A S H I N G T O N . WIG.