OPERATING INSTRUCTIONS
NOTE: Following delivery of your Simpson® power washer, inspect the unit for shipping damage and follow these directions:
1.Read all DANGER, WARNING, and CAUTION labels. Read the Owner's Manual that came with your machine before attempting to operate the power washer.
2.Fill the fuel tank with kerosene, or #1 or #2 diesel. DO NOT USE
3.Locate the unit in a convenient,
4.Connect 3/4” garden hose to quick connect. (Fig.2)
5Attach the garden hose with quick connect to the inlet nipple on the rear of the machine. (Fig.2) 6.Connect the high pressure hose to machine outlet. (Fig.2)
7.Connect the gun to high pressure hose. (Fig.2)
8.Turn on water supply.
9.Check all hose connections for leaks.
10.Connect the extension wand to the gun. (Fig.2)
11.Connect the GFCI power plug to a dedicated 120V, 60Hz, 15 Amp minimum power supply. Press the TEST button and then press the RESET button. The red light should be illuminated.
12.Point the wand in a safe direction and squeeze the trigger on the gun allowing air to purge from the system. Check the system for leaks.
13.Move the Pump switch to the ON position. (Fig.1)
14.Move the Burner switch to the ON position. (Fig.1)
CLEANING NOZZLES
Fig. 1
ON | ON |
PUMP SWITCH | BURNER SWITCH |
OFF | OFF |
Page 8 |
