BM 1619X03886 07-09:BM 1619X03886 07-09 7/23/09 10:54 AM Page 13
Accessories
!WARNING If an extension cord is necessary, a cord with
adequate size conductors that is capable of carrying the current necessary for your tool must be used. This will prevent excessive voltage drop, loss of power or overheating. Grounded tools must use
NOTE: The smaller the gauge number, the heav ier the cord.
RECOMMENDED SIZES OF ExTENSION CORDS 120 VOLT ALTERNATING CURRENT TOOLS
Tool’s | Cord Size in A.W.G. | Wire Sizes in mm2 | |||||||
|
|
|
|
|
|
|
| ||
Ampere |
|
|
|
|
|
|
|
| |
Cord Length in Feet | Cord Length in Meters | ||||||||
Rating | |||||||||
25 | 50 | 100 | 150 | 15 | 30 | 60 | 120 | ||
| |||||||||
|
|
|
|
|
|
|
| ||
18 | 16 | 16 | 14 | 0.75 | 0.75 | 1.5 | 2.5 | ||
18 | 16 | 14 | 12 | 0.75 | 1.0 | 2.5 | 4.0 | ||
18 | 16 | 14 | 12 | 0.75 | 1.0 | 2.5 | 4.0 | ||
16 | 16 | 14 | 12 | 1.0 | 2.5 | 4.0 | — | ||
14 | 12 | — | — | — | — | — | — | ||
|
|
|
|
|
|
|
|
| |
Trouble Shooting
!WARNING
PROBLEM
Read instruction manual first! Always lock trigger in the center “OFF” position before making adjustments or assembling accessories.
TROUBLE: TOOL WILL NOT START
1.Battery not charged.
2.Battery temperature is too hot or cold for operation.
3.Burned out switch.
REMEDy 1. If equipped, check battery charge condition lights for charge status. Charge battery if needed.
2.Let battery sit a few minutes or until it reaches normal operating temperature.
3.Have switch replaced by an Authorized Skil Service Center or Service Station.
TROUBLE: BATTERy WILL NOT CHARGE
PROBLEM 1. Charger not plugged into outlet.
2. Charger’s connector pin not completely inserted into tool.
REMEDy 1. Confirm charger is plugged into outlet.
2. Confirm charger’s connector pin is completely inserted into tool.
