Skil 6265 manual Operating Instructions, Variable Speed Controlled Trigger Switch

SM 2610912724 3/03 3/6/03 2:00 PM Page 7

Operating Instructions

VARIABLE SPEED CONTROLLED

TRIGGER SWITCH

Your tool is equipped with a variable speed trigger switch. The tool can be turned "ON" or "OFF" by squeezing or releasing the trigger. The speed can be adjusted from the minimum to maximum nameplate RPM by the pressure you apply to the trigger. Apply more pressure to increase the speed and release pressure to decrease speed (Fig. 1).

"LOCK-ON" BUTTON

The "Lock-ON" button, located in the handle of your tool allows for continuous operation at maximum RPM without holding the trigger (Fig. 1).

TO LOCK TRIGGER "ON": squeeze trigger, depress button and release trigger.

TO UNLOCK THE TRIGGER: squeeze trigger and release it without depressing the "Lock- ON" button.

!WARNING If the “Lock-ON” button is continuously being depressed,

the trigger can not be released.

FORWARD/REVERSING BUTTON

& TRIGGER LOCK

Your tool is equipped with a forward/reversing button and trigger lock located above the trigger (Fig. 1). This button was designed for changing rotation of the chuck, and for locking the trigger in an“OFF” position to help prevent accidental starts. For forward rotation, (with the chuck pointed away from you) slide button to the far right. For reverse rotation slide the button to the far left. To activate trigger lock move button to the center off position.

!CAUTION Do not change direction of rotation until the tool comes

to a complete stop. Shifting during rotation of the chuck can cause damage to the tool.

	INSERTING BIT
For small bits, open jaws enough to insert the		CHUCK
bit up to the flutes. For large bits, insert the bit FIG. 3
as far as it will go. Center the bit as you close		COLLAR
the jaws by hand. This positions the bit
properly, giving maximum contact between the		CHUCK
chuck jaws and the bit shank.
		SLEEVE
To tighten, hold the chuck collar firmly with one
hand and securely tighten the chuck sleeve
with the other hand (Fig. 3).
! WARNING	To prevent friction burns, or
	possible hand injury, do not

loosen or tighten the chuck by using the power of the drill.

SITE-LIGHT™ (Model 6265 only)

Your tool is also equipped with a Site-Light™ for better visibility during operation (Fig. 2).

When the tool is plugged in, the light will turn on automatically when the user grips the handle and covers the sensor.

The Site-Light™ is maintenance free and was designed to last the life of your tool.

Note: When holding the tool, always make sure the sensor in the handle is completely covered when activating the light.

BIT STORAGE AREA

Your tool is equipped with a bit and storage area that is conveniently located in the handle base where it is always handy and unlikely to get lost or misplaced (Fig. 1).

-7-