SM 2610008537
Sanding Accessories Assembly
BACKING PAD
Before attaching a backing ! WARNING pad be sure its maximum
safe operating speed is not exceeded by the nameplate speed of the tool.
! WARNING Wheel guard may not be used for most sanding
operations. Always reinstall wheel guard when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Set the tool on its top side (spindle up). Place the rubber backing pad onto the spindle shaft. Center the sanding disc on top of the backing pad. Insert the lock nut through the disc and thread onto the spindle as far as you can with your fingers. Press in the spindle lock, then tighten the backing pad securely with lock nut wrench (Fig. 4).
TO REMOVE BACKING PAD AND
SANDING DISC
Disconnect tool from power source. Using the lock nut wrench unscrew the nut from the spindle, while holding spindle lock in.
WIRE BRUSH ASSEMBLy
Before assembling wire brush to this tool, disconnect from the power source. Wire brushes are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
Always use type 27 guard ! WARNING system with wire wheels and
assure that wires fit within guard.
WIRE WHEEL ASSEMBLy
Before assembling wire wheel to this tool, disconnect from the power source. Attach type 27 guard (Fig. 2). Wire wheeels are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
FIG. 4
SPINDLE
BACKING
PAD
SANDING
DISC
LOCK NUT
WIRE BRUSH
Operating Instructions
SLIDE ON-OFF SWITCH WITH LOCK
The tool is switched “ON” by the switch button located at the side of the motor housing. The switch can be locked in the “ON” position, a convenience for long grinding operations.
TO TURN THE TOOL “ON” without locking it, slide the switch button forward by applying pressure ONLY at the REAR portion of the button. When pressure is released the switch button will snap to “OFF” position (Fig. 5).
TO LOCK THE SWITCH “ON”, slide the switch button forward and press “IN” the FRONT portion.
TO UNLOCK THE SWITCH, simply press and release the REAR portion of the button. Switch is spring loaded and will snap back automatically.
FIG. 5 | SWITCH |
| BUTTON |
