WS-100 Wireless Remote Control - IMPORTANT SAFETY INSTRUCTION
Introduction
Skylink wireless remote allows you to operate any electrical appliance (that meets the product's rating) indoors or outdoors without rewiring. Enclosed you
will find:
Installation
Plug in the receiver to an electrical outlet (indoors)
Plug in the receiver to an electrical outlet fully. The receiver requires a grounded outlet. If you do not have a grounded outlet, please contact an electrician to upgrade your electrical system.
If you are using the receiver outdoors, read the extra pre- cautions below.
Plug in the receiver to an electrical outlet (outdoors)
Plug in the receiver to an electrical outlet fully. Let the receiver hang downward so moisture doesn't accumulate in the outlet. Install cord and unit above ground level with the receptacle in downward position. A weather protective cover must be used in order to prevent rain or moisture from enter- ing the unit.
Note: Not for water immer- sion or for use where direct exposed to water. Store in- doors when not in use.
Note: The National Electrical Code and Canadian Electrical Code (and most local codes) require that outside outlets
Operation
Press the button on the transmitter (battery already installed), the light on the transmitter will turn on and the device you plugged into the receiver should also be on immediately. Press the button on the transmitter again to turn the device off.
Battery Replacement
Use
To replace, open the battery compartment cover, and replace the old battery with a new one. Do not dispose of battery in fire. Battery may explode or leak.
Caution
Risk of electric shock, do not use with extension cord or near water or where water may accumulate. Keep plugs and receptacles dry. For use only on GFCI protected circuits.
Warranty
If, within one year from date of purchase, this product should become defective (except battery), due to faulty workmanship or materials, it will be repaired or replaced, without charge. Proof of purchase is required.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.This device may not cause harmful interference, and
2.this device must accept any interference received, including interference that may cause undesired operation.
WARNING
Changes or modifications to this unit not expressly approved by the party responsible of compliance could void the user’s authority to operate the equipment.
Skylink will not be held liable or responsible for any misuse or application of this product other than for its intended use.
be protected by a Ground Fault Inter- rupter (GFI).
Power Outlet
Specification
Plug in the device you wish to control into the outlet
located on the bottom of the receiver
Do not exceed the maximum load specifications listed. If you are not sure what is the rating of an appliance, check with an electrician before plugging it into the receiver.
RANGE: Up to 100 feet |
|
INPUT: 120VAC 60Hz |
|
MAXIMUM LOAD: |
|
RESISTIVE | 8A (960W) |
INCANDESCENT | 300W |
BATTERY (TRANSMITTER):
