Slant/Fin VHS-150, VHS-120, VHS-90 Flame Roll-Outsafety Shut-Offswitch, Safety Information

VICTORY II VHS MODELS

2.Remove jacket top.

3.Remove inducer assembly.

4.Remove flue collector.

5.Use wire brush to clean flue passages.

6.Replace flue collector and re-seal with furnace cement.

7.Replace inducer assembly, jacket top and control top.

8.Remove and dispose of paper and accumulated material.

Figure 8.

B. Cleaning of burners

If burners’ surfaces are not clean, or uneven flame indicates plugged burner parts, remove and clean burners.

1.Remove pilot gas line at gas valve.

2.Disconnect pilot burner assembly from pilot bracket.

3.Lift burner and remove burner from orifice.

4.Clean burners. To clean burners, run a clean flue brush up the tube until all foreign matter is removed.

5.Replace burners, pilot assembly, ignitor and sen- sor wires.

6.Adjust burners and pilot flame.

C.Adjust main burners and pilot flames. See “Installation and Operating Instructions”, for instruc- tions.

D.Check input gas rate to the burners. See “Installation and Operating Instructions”, for instruc- tions.

E.To prolong the life of inducer motor, lubricate with 6 drops of Anderol 465 annually.

FLAME ROLL-OUT SAFETY SHUT-OFF SWITCH

All Victory II boilers are equipped with a single use flame roll-out safety shut-off switch. It will shut off main gas burners in the event the flow of combustion prod- ucts through the boiler flue passages are reduced. If this safety switch has actuated to shut off the main burners, DO NOT attempt to place the boiler in operation, but contact a qualified service agency.

SAFETY AND OPERATING INSTRUCTIONS Follow the lighting instructions in this manual. These instructions are also attached to the boiler.

SAFETY INFORMATION

For Your Safety Read Before Operating

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.

A. This appliance is equipped with an ignition device which automatically lights the pilot. DO NOT try to light the pilot by hand.

B. BEFORE OPERATING smell all around the appli- ance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS:

•DO NOT try to light any appliance.

•DO NOT touch any electric switch: DO NOT use any phone in your building.

•Immediately call your gas supplier from a neigh- bor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

6