PLS8695 True Line Source Array Owner’s Manual | Page 6 |
3.8Status Indicators
“CLIP” indicates when Channel 1 is clipping. “PROT” indicates when the power supply protective circuitry has been engaged. It may be necessary to cycle the power to reset the protective circuitry. “PWR” indicates that power is present in the amplifier. “SIG” indicates that signal is present at the input of the amplifier.
3.9Programming Port
This port is used by SLS to program the EEPROM for DSP processing data. It requires a proprietary interface and is not user assessable.
3.10Programming Selection
This switch allows the selection between two different EQ settings stored in EEPROM. Pushed in is optimized for a single PLS8695. Pushed out is optimized for two PLS8695s stacked on top of each other. This is "boot up" enabled so in order to make the EQ change: power off the PLS8695, select the button position desired and re- power. It will boot up with the selected EQ programming.
3.11Mute Switches (in - signal passes, out - muted)*
These switches mute the individual amplifier channels for setup and troubleshooting purposes.
* Buttons are reversed from typical settings to protect them from damage when they are in typical positions.
4. Specifications
Product Specifications
Operating Range | 80 – 20,000Hz |
Horizontal Coverage Angle | 120 Degrees |
Vertical Coverage Angle | Defined by height of the array |
Input Sensitivity | 1.88V RMS |
Max SPL (calculated) @ 1 Meter | 130dB peak |
Amplifier Power High Freq. | 500 Watts |
Amplifier Power Low Freq. | 1000 Watts |
AC Power Consumption | 11 amps at full rated output |
Crossover Frequency | 1500Hz |
Transducers – High Freq. | 9 x PRD500 Ribbons |
Low Freq. | 8 x 6.5 Woofers |
| 55.5” (141cm)H |
Dimensions | 11.5” (29.2cm)W |
| 12” (30.5cm)D |
Weight | 110lbs (50kg) |
| Rugged weather resistant latex |
Enclosure | paint - in black, white, or |
| paintable natural birch |
Rev: 512 | 1650 W. Jackson Ozark, MO 65721 (417) |