Smart Technologies DT770 Reattaching the Connection Panels Protective Cover

10 Installing the DT770

3. Place the pen in the recess below the interactive screen so that it’s available for use. The

recess holds the pen magnetically.

Reattaching the Connection Panel’s Protective Cover

If you wish, after you have connected all of the DT770’s cables, you can reattach the protective

cover.

1. Feed the cables through the semi cylindrical channel in the back of the DT770 so that when

you reattach the protective cover, it will not trap any of the cables. Then place the cover over

the connection panel.

2. Tighten the captive screws using the supplied screwdriver.

To reattach the protective cover

Pen Recess

Semi-cylindrical

channel

NOTE: For clarity, the

DT770 is shown

without the cables

NOTE: If you like, you can

feed the pen’s tether through

the gap at the bottom of the

cover, instead of through the

semi-cylindrical channel.

Contents

Main Registration Benefits Important Information Other Precautions Table of Contents Page Overview Interactive Screen Tethered Pen Pen Tool Buttons Function Buttons Display Control Buttons Room Control Interface Button Connection Panel Power Supply The Power and Status LEDs Mono Stand Page Installing the DT770 Determining the Best Location for Your DT770 Removing the Connection Panels Protective Cover Connecting the DT770 To connect the DT770 To remove the protective cover Integrating a Monitor or a Projector Connecting the Tethered Pen To connect the tethered pen to the DT770 To connect a projector or monitor to the DT770 Reattaching the Connection Panels Protective Cover To reattach the protective cover Mounting the DT770 on a Mono Stand To install the DT770 on the mono stand Securing the DT770 Turning on the DT770 To install SMART Board software Installing SMART Board Software Matching the Screen and Computer Resolutions To set the resolution for the Windows operating system To set the resolution for the Mac OS X operating system Orienting the Screen To change the orientation level to Quick (4 Points) (Windows Operating Systems) To orient the screen To change the orientation level to Quick (4 Points) (Mac Computers) Using the DT770 Touching the Interactive Screen Using the Pen Tool Buttons Clicking and Mouse Mode Right-Clicking Writing on the Screen and Saving Your Notes Using the Eraser Using the Function Buttons To erase a note To open the Screen Capture tools To open the SMART Keyboard To open Notebook software To open the Floating Tools Using the Room Control Interface Button Customizing Buttons To customize a button (Mac Computers) To customize a button (Windows operating system) Setting the Pen Tool Defaults Enabling Pen Touch Only or Finger Touch Only Mode To set the pen tool default To enable Pen Touch Only or Finger Touch Only mode Cleaning the DT770 Cleaning the Interactive Pen Display Page Troubleshooting Checking the Power of the Interactive Pen Display Checking the Status of the Interactive Pen Display Image Problems Control and Writing Problems Troubleshooting Summary Table Calibrating the Cameras Appendix A: Adjusting the Screen Settings To adjust the screen display settings To reset the screen display settings to the factory defaults Waste Electrical and Electronic Equipment (WEEE) Regulations Page Customer Support Training Contacting SMART Technical Support Page Index A C D E T U W