10 | KNOWLEDGE BASE – MAINTAINING YOUR SMART UF75 PROJECTOR
To center the projected
image
If the image is off center, use a wrench to turn the adjustment screw on the
mounting base.
• Rotate the adjustment screw clockwise to move the entire image to the left.
• Rotate the adjustment screw counterclockwise to move the entire image to
the right.
Resetting the lamp timer
After you replace the lamp, access the projector service menu to reset the lamp hour
counter. To prevent accidental errors, only a system administrator should perform this
procedure.
CAUTIONS
• Always reset the lamp hours after you replace the lamp, because lamp
service reminders are based on the current hours of use.
• Do not adjust any settings in the service menu other than those listed in this
guide. Changing other settings can damage or affect the operation of your
projector and invalidates your warranty.
To reset the lamp timer 1. Press the remote control buttons quickly in teh following sequence to access the
service menu: Down-Up-Up-Left-Up.
2. Scroll to Lamp Hour Reset, and then press OK.
Both Lamp Hour values (Standard and Economy) are reset to zero.
CAUTION
Do not use the Lamp Hour Reset feature unless you have just replaced the
lamp. Resetting the lamp hour counter on an old lamp can rsult in lamp failure
and projector damage.
NOTE
You’re unable to reset the Display Hours value because it’s the running total
of hours the projector has been in use.
3. Press the Menu button on the remote control.