Smartek ST-2000 manual HOW to Fill with Water

HOW TO FILL WITH WATER

Make sure the iron is turned off and the AC Power Cord is unplugged from the electrical outlet. The iron can be filled with the Detachable Water Tank in place or removed. Set the Cord Switch to “Cordless” Remove the iron from the stand.

1.When the iron is sitting up on the Heel Rest, press the Tank Lock/Release Button down and the tank will be released.

2.Grasp the tank and lift it off the iron.

3.Open the Water Fill Opening and fill the Tank up to the “MAX” Line on the tank. To check the level of water, grasp the tank vertically.

4.To re-install the tank, set the tank onto the main body and press into place until a click sound is heard.

5.The water level can be observed through the transparent part of the tank, when iron placed vertically. When the water level becomes low,

refill the tank, following the procedure described in steps 1 to 4 above.

NOTE:

Most tap water can be used in this iron. Do not use water additives or substitute water such as linen or scented water in the steam iron, they can stain fabrics or damage the iron. Do not fill the water more than the “MAX” position

7