AR-B1462 User¡¦s Guide

6-9

Step 7: In the main menu, choose the <Load ROM File> item, that is the ROM_NAME=[file name] in the *.PGF
file.
Choose the <Program Memory> item, this item program will program the EPROMs.Step 8:
NOTE: Move the reverse video bar to the <Program memory> option then press <ENTER>.
Reboot the systemStep 9:
NOTE: Reboot your computer by making a software or hardware reset.
6.4.3 Small Page 5V FLASH ROM Disk

(1) Switch and Jumper Setting

Step 1: Use jumper block to set the memory type as ROM (FLASH).
Step 2: Select the proper I/O base port, firmware address, disk drive number and EPROM type on SW1.
Step 3: Insert programmed EPROM(s) or FLASH(s) chips into sockets starting at MEM1.
ON
12345678910
OFF
Figure 6-8 5V FLASH (29CXXX & 28EEXXX) Switch Setting
M1, M2, M3, & M4
5V FLASH (64KX8, 128KX8 and 256KX8)
(Factory Preset)
5V FLASH (512KX8 Only)
M1, M2, M3, & M4
1
2
3
A B C
1
2
3
A B C
1
2
3
JP8
1
2
3
JP8
Figure 6-9 5V FLASH (29CXXX & 28EEXXX) Jumper Setting