SMC Networks SMC9462TX A T

PPENDIX

Early PCI BIOS versions do not properly sup port the PCI

specification and may “hang” when a network card driver tries to

load. If this occurs, make sure your BIOS correctly supports the PCI

Local Bus Specification (v2.2 or later) and upgrade your computer

BIOS to the latest version.

Some PCI computers are not self-configuring and require you to

perform some or all of the following functions by motherboard

jumper changes and/or BIOS Setup program configuration:

◆Verify that the PCI slot is an enabled busmaster slot and not a

slave PCI slot. The EZ Card 1000 must be insta lled in a PCI

busmaster slot. In some computers the PCI slot must be

configured to enable bus mastering. Refer to your PC’s manual

and check the PCI BIOS Setup program to be sure the PCI slot

is an enabled busmaster slot.

◆In some computers, you may be required to disable Plug ‘n Play

(PnP) in the BIOS Setup program if resources are not properly

assigned between the network card and other installed cards.

◆Some computers may require you to reserve inter rupts and

memory addresses for installed ISA cards to pre vent PCI cards

from using the same settings. Refer to your P C’s manual and

check the PCI BIOS Setup program configuration options for

ISA cards.