Instructions for the Installer
4.2 Fully Built-In Version
Minibars can easily be built into any suitable cabinet. It is essential to comply with the following guidelines:
1Make sure that sufficient ventilation can reach the refrigeration unit, on the rear of the minibar.
2Sketches A, B and C (fig. 2) show various alternatives for
3The ventilation gaps, for both incoming and outgoing air, must measure at least 200 cm2 and it is
indispensable to take care that any ventilation grilles cannot be obstructed in any way. All minibar models are equipped:
-with two fixing plates in the base;
-with a door with linkage fixtures for opening and closing, which connect the door of the appliance to the door of the cabinet in which it is to be
The minibar is delivered with the door hinged on the
If you wish to open it in the other direction please refer to paragraph “4.5 Changin the doorhang”. The top
Place the minibar inside the cabinet, centring it so that any gaps are the same on both sides.
Move it backwards or forwards so that the gap between the cabinet and appliance doors does not exceed
2) 3)
To fix the bracket which links the appliance door to the door of the cabinet, proceed as follows. Make two holes to which the bracket will then be fixed, referring to the measurements shown in figure 4.
4)
18