Instructions for the installer
2.2 Fixing the flush-top model to the structure.
dimensions shown in the figure in the top surface of the counter,
keeping a minimum distance of 50 mm from the rear border.
This appliance is classified as “type Y” in relation to fire hazards and can therefore be mounted against walls higher than the work surface on condition that a certain distance “X” be kept between the appliance and the wall as shown in the figure so as to avoid damage from overheating.
Make sure there is a minimum of 750 mm between the hot plate flames and any shelf that may be installed directly above them.
2 
3 
This type of appliance also requires a cut 2 mm deep in the worktop of the size shown in figure 3. Before putting the worktop in place, fit the gasket right around the perimeter of the appliance and make sure that it fits snugly against the metal.
The gasket must be fitted as shown in figure 5.
4 | 5 |
The appliance can also be installed using silicone instead of the gasket supplied. In this case, the installer is responsible for ensuring that the appliance is perfectly level with the top of the unit.
2.3 Electrical connection
Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this
plate for any reason.
The plug on the end of the supply cable and the wall socket must be the same type and conform to the current electrical system regulations. Check that the power line is adequately grounded.
20
