Smeg AS62C Solution suggestions for problems, Call an authorized service if the problem persists

6Solution suggestions for problems

Problem	Cause	Explanation / Suggestion
Drying process takes	Cover filter and filter drawer might have	* Clean the cover filter and Filter drawer.
too much time.	not been cleaned.
	* Cover filter and filter drawer might
Laundry come out wet	have not been cleaned.	* Clean the cover filter and Filter drawer.
at the end of drying.	* Excessive laundry might have been	* Do not overload the machine.
	loaded in.
	* It might have not been plugged in.	* Make sure that the machine is plugged
	* The loading door may be ajar.
		in.
	* Program might have not been set or
Machine does not		* Make sure that the loading door is
	the “Start/Pause/Cancel” button might
switch on or the		properly closed.
	have not been pressed.
program does not		* Make sure that the program has been
	* “Childproof lock” might have been
start. Machine is not		set and it is not in “Pause” mode.
	activated.
activated when set.		* Deactivate the childproof lock.
	* The condenser cover on the models
		* Make sure that the condenser cover
	with a condenser might not be closed
		and the red lock is closed securely.
	securely.
Program has been		* Make sure that the loading door is
	* The loading door may be ajar.	properly closed.
interrupted without
	* Electricity may be cut off.	* Press “Start/Pause/Cancel” button to
any cause.
		start the program.
		* Dry only the laundry which is suitable
Laundry has shrunk,		for drying in your machine after checking
	* A program suitable for the laundry	the labels on your clothes.
become felted or
	type might have not been used.	* Select a program with suitable low
deteriorated.
		temperature for the laundry type to dry
		your clothes.
Drum lightning does	* The machine might have not been	* Make sure that the machine is On.
not come on.
	started by using the On/Off button.	* Call the authorized service to replace
(for models equipped
	* Bulb may have blown.	the bulb.
with a lamp)
“Final / Anti-creasing”	* The 2-hour anti creasing program to	* Turn off the machine and take out the
	prevent laundry from creasing might
LED flashes.		laundry.
	have been activated.
“Final / Anti-creasing”	* Program has come to an end.	* Turn off the machine and take out the
LED is on.		laundry.
The “Drying” LED	* A heat sensor failure has occurred.	* Turn off the machine and take out the
	Machine ends the program without
flashes.		laundry. Call your authorized service.
	heating.
Also for products equipped with a condenser
“Water tank” warning	* Water may be full.
	* Anti-creasing program might be	* Drain the water in the water tank.
LED is on.
	running.
“Filter cleaning” LED	* Filter might have not been cleaned.	* Clean the cover filter.
is on.
“Condenser cleaning”	* Filter drawer/Condenser might have	* Clean the filters in the condenser/filter
LED is on.	not been cleaned.	drawer under the kick plate.

A Call an authorized service if the problem persists.

12 - EN