Smeg BL1S, BL2 Electronic Setting, Setting Water Hardness Regeneration, Performed every cycle

User instructions

ELECTRONIC SETTING

The value entered for this parameter establishes whether or not regeneration is to be carried out at the end of the washing cycle, on the basis of the table below.

SETTING	WATER HARDNESS	REGENERATION
0	< 9°dH (15°dF)	Not performed
1	< 15°dH (25°dF)	Performed every 5 cycles
2	< 23°dH (40°dF)	Performed every 4 cycles
3	< 34°dH (60°dF)	Performed every 3 cycles
4	< 46°dH (80°dF)	Performed every 2 cycles
5	< 58°dH (100°dF)	Performed every cycle

Contact your local water board for information on the hardness of your water supply. N.B.: a cycle is a washing program.

Programming procedure:

•Press the PROGRAM SELECTION (2) and DELAYED START (3) buttons simultaneously for 3 seconds until the DISPLAY (7) shows the symbol “H”;

•Press the DELAYED START button (3) to modify the parameter;

•Press the PROGRAM SELECTION button (2) to exit from the procedure.

SWITCH SETTING

According to the machine model, the selector which acts on the adjustment may be located:

•inside the plastic locking ring located on the right-handside, inside the dishwasher;

•inside the water softener, just below the cap.

Both allow for adjustment to 5 settings:

35