Smeg BLV1R E7 E8 E9, User instructions, Fault, Description, Turbine flow-regulator malfunction

User instructions

E7

E8

E9

26

FAULT	DESCRIPTION
	Turbine flow-regulator malfunction
	(for the relevant models only)
	The appliance is not able to "measure" the amount of
	water loaded accurately. Interrupt the program and
	switch off the dishwasher. Switch the dishwasher
	back on, program it again and start the washing
	cycle. If the problem persists, contact the after-sales
	service.

Alternate washing system malfunction

Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after-sales service.

Water intake system malfunction

Contact the after-sales service.

Light off Light on Light flashing

If an alarm occurs the appliance interrupts the program in progress and signals a fault.

•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program immediately.

•The E5, E6 alarms interrupts the running program once the cause is resolved, it will bring bach the execution of the program.

•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

•Open and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.