END of Cycle, Removing the Dishes | Smeg CA01-3 specification

User instructions

If it is necessary to open dishwasher door during the washing cycle, there will be a 1-minute delay before the program can be resumed. After correctly closing the door, the washing program will start again from where it was interrupted. This operation may negatively affective the progress of the washing cycle.

END OF CYCLE

At the end of the washing program the selector will be on one of the STOP markers, depending on the program carried out.

Switch off the dishwasher by pressing the ON/OFF key (2) (see section "3. Description of the controls").

4

3	2		5			1
	4

3

2

5

1

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

16

Image 7

Smeg CA01-3 instruction manual END of Cycle, Removing the Dishes

Contents

For Cleaning Dishwashers Contents Description of the controls Setting the Washing ProgramFront panel Table of Programs Correct amount of detergent has been added to the dispenser Cancelling the Current ProgramWashing programs Before starting a washing program make sure that To Save on ENERGY! … and Protect the Environment Removing the Dishes END of Cycle Water Hardness Table Adjusting the Water Softening System For Cleaning Dishwashers Contents Safety and operating instructions Safety instructions Safety instructions Aquastop Models For free-standing models only Installation and hook-up Water supply connection Connecting to the Water SupplyDrain Connection If the Appliance is Provided with a Plugless Supply Cord Electrical connection and precautions For Great Britain only When Cleaning and Maintaining the Appliance Operating instructions Using the water softening system Using the rinse aid and detergent dispensers Adding the Rinse AID Adjusting the Rinse AID Dispenser Setting Adding the Detergent Products General warnings and recommendations User instructions EN 50242 Standard Loads for Certification Bodies Using the baskets Loading the Lower Basket Lower Basket Upper Basket Cutlery Basket Loading the Upper Basket Version B Adjusting the Upper Basket User instructions Cleaning the Water Intake Filter Cleaning and maintenanceCleaning the Spray Arms Fill the rinse aid dispenser Shut off the water supply tap Cleaning the Filter Unit If water remains inside the dishwasher, check that If the dishes are not being cleaned properly, check thatReconnect the water intake hose and open the tap again If the program fails to start, check that If there are visible traces of rust inside the tank If the dishes fail to dry or remain dull, check that 135 145