Smeg CO300, CO400 manual Safeguarding the Environment, AFTER-SALES Service

GB

INSTRUCTIONS FOR USE

3.The green LED (if provided) is off and the appliance is not working.

•Is there a power failure?

•Is the plug properly inserted in the socket?

•Is the electric cable intact?

4.The green LED (if provided) is off and the appliance is working.

•The green LED is not working. Contact the After Sales Service for a replacement.

5. The compressor runs continuously.

•Have hot foods been put in the appliance?

•Has the appliance lid been left open for a long time?

•Is the appliance positioned in a very warm room or near heat sources?

•Is the thermostat setting correct?

•Has the fast freeze function (depending on model) been pressed by mistake?

6. Too much ice on the upper edge.

•Are the defrost water drainage plugs correctly positioned?

•Is the appliance lid properly closed?

•Is the appliance lid seal damaged or deformed? (See chapter “Installation”)

•Have the 4 protection pieces been removed? (See chapter “Installation”)

7.Condensation forms on the external walls of the appliance

•It is normal for condensation to form under certain atmospheric conditions (humidity above 85%) or if the appliance is located in a damp or poorly ventilated room. The performance of the appliance is in no way affected.

8.The layer of ice on the internal walls of the appliance is not uniform.

•This phenomenon is quite normal.

SAFEGUARDING THE ENVIRONMENT

1. Packing

The packaging material is entirely recyclable, and marked with the recycling symbol. Follow local regulations for scrapping. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.

2. Scrapping

The appliance is manufactured using recyclable material . This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).

By ensuring this product is disposed of correctly, you can help prevent potential damaging consequences for the environment and human health.

The symbol on the appliance, or on the accompanying documents, indicates that this appliance should not be treated as household waste, but must taken instead to a suitable collection point for the recycling of electrical and electronic equipment.

Before scrapping, make the appliance unusable by cutting off the power cable and removing the doors and shelves so that children cannot easily climb inside the appliance.

Disposal must be carried out in accordance with local environmental regulations for waste disposal. Deliver the appliance immediately to an authorized dump; do not leave it unattended even for a few days, since it is potentially dangerous for children. For more detailed information about treatment, recovery and recycling of this product, please contact your competent local authority, your household waste disposal service or the shop where you purchased the appliance.

Information:

This appliance does not contain CFCs. The refrigerant circuit contains R134a (HFCs) or R600a (HCs), see the rating plate inside the appliance.

Appliances with Isobutane (R600a):

Isobutane is a natural gas with low environmental impact. Caution is required, however, since isobutane is flammable. Therefore, it is essential to ensure that refrigerant pipelines are not damaged.

This product contains Fluorinated Greenhouse Gases covered by the Kyoto Protocol, the refrigerant gas being in a hermetically sealed system. Refrigerant gas: R134a has a Global Warming Potential (GWP) 1300.

Declaration of conformity

•This appliance is designed to store food and is manufactured in conformity with European Directive 90/128/EEC, 02/72/EEC and Regulation (EC) No. 1935/2004

•Thisappliance is designed, manufactured, and retailed in compliance with:

-the safety objectives prescribed in the Low Voltage Directive 2006/95/CE (which replaced Directive 73/23/CEE as amended);

-the protection requirements of the "EMC" Directive 89/336/EEC amended by Directive 93/68/EEC.

•The electrical safety of the appliance can only be guaranteed if the product is connected to an approved earth connection.

AFTER-SALES SERVICE		Before calling the After-sales Service, be sure to have
Before calling out an After-sales Service technician,		the following information ready:
make sure that:		• your full address and telephone number;
1.	the plug is properly inserted in the socket;	• the appliance model;
2.	the mains electrical supply is present;	• the serial number (“S/N”) of the appliance, indicated on
		the accompanying documentation and on the data plate on
3.	the meter box safety switch has not tripped;
		the rear of the unit;
4.	the power supply voltage corresponds to that indicated
		• the nature of the fault.
	on the appliance;
5.	if the problem persists, contact the After-sales Service,	* Maximum cost 14 cents/min (VAT included) without connection charge
	tel. 199.135.135 * (in contact with your local area
	Technician).	from landlines. Average cost 39 cents/min (VAT included) and maximum
		connection charge of 15 cents (VAT included) from mobile networks.

For further details on mobile charges, contact your network operator.