Trouble Shooting Guide
During the service, you can come across some troubles that in most cases result from improper handling of the appliance and can easy be eliminated.
The Appliance Fails to Operate After Connecting to the Mains Supply
•Check the supply in the outlet socket and make sure the appliance is switched on (the green light is on).
The Red Light is On
•The door was frequently opened or it was left opened for too long.
•The door is not properly closed (the door may sag, the gasket may be polluted or damaged).
•Power supply has been interrupted for a longer period of time.
•Perhaps you have overloaded the appliance with fresh foods.
Continuous Operation of the Cooling System
•Set the operation mode selection switch from continuous to automatic operation.
•The reason may be inadequate ventilation of the compressor and condenser (assure adequate air circulation behind the appliance and wipe the dust from the condenser).
•During the operation of the compressor the noise of liquid is heard and when the compressor is not operating, the refrigerant flow is heard. This is a normal condition and it has no influence whatsoever on the lifetime of the appliance.
•After starting the appliance, the operation of the compressor and the refrigerant flow may be louder, which does not mean that something is wrong with the appliance and it has no influence on the lifetime of the appliance. Gradually the noise is reduced.
•Sometimes unusual and stronger noise is heard, which is rather unusual for the appliance. This noise is often a consequence of inadequate placing. (The appliance shall be placed and levelled firmly on solid base and it should not touch the wall or kitchen units standing next to it.)
Bulb Replacement
(models with interior illumination only)
Before replacing the light bulb, disconnect the appliance form the power supply.
Remove the plastic cover with the screwdriver and replace the bulb with a new one (E14, max. 15 W).
Don't forget: the old bulb does not belong to organic waste.
Light bulb is consumning good therefore our
The Door is Hard to Open
If you want to open the door that has just or recently been closed, you may find it hard to open. The reason why this happens is, that when you open the door, warm air gets into the appliance and when it is cooling, the underpressure seals the door. After few minutes
Noise
Cooling in
:(5(6(59(7+(5,*+772$/7(57+(63(&,),&$7,216:,7+12,1)/8(1&(
217+(23(5$7,212)7+($33/,$1&(
Instructions for Use | 51 |