The dimensions for building in are noted on the drawings.
It is safest to place the earthed wall socket above the appliance and at least 2.0 m above the floor.
Any local installation rules for appliances of this kind must be observed.
During a storm the electricity supply might be cut off.
You should be aware of this when installing the appliance in weekend cottages or elsewhere where you would not immediately observe that the power has been cut off. Construction and details in the accessories are subject to alteration without previous notice.
If the cabinet is to be adjusted:
See drawings (1) page 20.
Take hold of the front panel with both hands. Then lift up the front panel and turn out the bottom part.
Adjust the tilt of the unit
See drawings (1) page 20.
by turning the adjustable feet with a 13 mm spanner.
Adjusting the door
See drawings (1) page 20.
If the door bumps against the bottom panel, this can be remedied by adjusting the feet as shown on the drawing.
9. CHANGE OF HINGE SIDE
See drawings page 22.
1)Dismantle the top hinge. This one is to be used later as top hinge at the opposite side. Lift off the top door.
2)Remove the kick panel.
The bottom hinge is dismounted at the 3 screws. The hinge is turned 180° and mounted
on the opposite side.
3)Adjusting the bottom door: Loosen the 3 screws in the bottom hinge and push the bottom hinge to the required side. Tighten the screws and mount the kick panel.
4)The kick panel is mounted and the hole plugs are mounted on the opposite side.
5)Ajustment of the top door: loosen the screws in the hinge above the door, loosen the hinge above the door and turn the hinge to the wanted side. Tighten the screws.
6)Move the handle.
DISPOSAL OF THE
APPLIANCE
The appliance contains recyclable materials. When disposing of the appliance, please contact the technical administration or other appropriate authority in your municipality. They can inform you of the collection and recycling measures used in the municipality.
6
