Smeg DWD63BLE User instructions, Deleting The Program In Progress, Modifying The Program

User instructions

DELETING THE PROGRAM IN PROGRESS

To delete a program which has already been started, press the START/STOP button (3) until the beep is heard; when the button is released the program will stop. Press the START/STOP button

(3)again, wait for the beep and keep the button pressed for another 6-8 seconds, until the rinsing and drying phase lights come on simultaneously. The appliance will now pump out the water and the dishwasher can be switched off by pressing the ON button (2).

MODIFYING THE PROGRAM

To modify the program in progress, it must first be stopped by pressing the START/STOP button

(3)and keeping it pressed until the beep is heard. The lights relating to the phases of the program will reset in accordance with the program set. Make the new selection and restart the program by pressing the START/START button (3) again, keeping it pressed until the beep is heard.

PROGRAM DELAY

The start of the washing program can be delayed from 1 to 9 hours. This allows you to operate the dishwasher at the time of day most convenient to you.

After setting the washing program and STARTING UP THE DISHWASHER using the START/STOP button (3), the "delay" required can be set using the DELAYED START button (9). The hours left before the start of the program will be shown on the DISPLAY (10).

TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT

•Always try to run the dishwasher fully loaded.

•Do not wash the dishes in running water.

•Use the washing program that is most appropriate for each type of load.

•Do not carry out any preliminary rinsing.

•If available, connect the dishwasher to a hot water supply up to 60°C.

•When possible, disable the drying cycle and leave the door open at the end of the washing cycle: the residual air and heat will dry the dishes perfectly.

TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using excessive amounts of detergent and to save on electricity, observe the following:

•separate the more delicate items from dishes that are more resistant to aggressive detergents and high temperatures;

•do not pour the detergent directly on the dishes.

REMOVING THE DISHES

At the end of the washing program, wait at least 20 minutes before removing the dishes, to allow them to cool down. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket.

29