Before contacting After-Sales Service:
1.See if you can solve the problem yourself with the help of the “Troubleshooting guide”).
2.Switch the appliance on again to see if the problem persists.
If it does, switch off and wait for about an hour before switching on.
3.If the problem persists after this course of action, contact
Specify:
•the nature of the problem,
•the model,
•the Service number (the number after the word
SERVICE on the data plate on the inside of the appliance),
•your full address,
•your telephone number and area code.
Note: The direction of door opening can be
INSTALLATION
•Install the appliance away from heat sources.
•Install the appliance in a dry,
•Do not obstruct the top and bottom vent zones.
•Clean the inside (see chapter “How to clean the refrigerator compartment”).
•Fit the accessories supplied.
Electrical Connection
•Electrical connections must be made in accordance with local regulations.
•Voltage and power consumption are indicated on the rating plate (at the side of the crispers).
Freestanding appliances (not built-in)
•Fit the spacers (if supplied) on the rear of the condenser positioned at the back of the appliance (see figure).
•To optimize appliance efficiency, leave a 5 cm gap above the appliance and make sure that adjacent kitchen units are sufficiently distanced to allow air circulation.
•Ensure that the appliance is level, using the front adjustment feet if necessary.
•Regulations require that the appliance is earthed. The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the above procedures and reminders.
•If the plug and socket are not of the same type, have the socket replaced by a qualified electrician.
•Do not use extension leads or adapters.
Disconnecting the appliance
•It must be possible to disconnect the appliance by unplugging it or by means of a
19
